
-
Ampule of sterile saline
- Ampules of medication (powder)
- 3 cc syringe with 1 ½” needle
- 30 gauge ½” needle
- Alcohol wipe
-
Wash your hands
- Pop tops off of all the ampules that you will use for this dose
- Pop top off of ONE ampule of sterile saline
- Remove syringe from wrapper,& tighten needle
-
Push needle through rubber stopper of saline ampule, and draw out 1 ml of saline. (ampule contains 2 ml)
-
Push needle through rubber stopper of first medication ampule, inject liquid slowly. You may gently swirl it with the needle still in the ampule to mix.
-
When medication is thoroughly mixed, pull the medication back up into the syringe.
-
For each other ampule, repeat steps 6 and 7.
-
Recap the needle and remove it by unscrewing it and attach the 30 gauge needle by screwing it firmly onto the syringe. Leave the cap on until ready to inject.
-
Sit comfortably, and expose the area to be injected; usually the abdomen, to the side of the belly button.
-
Wipe the site with alcohol.
-
Remove the needle cover, hold the syringe in your dominant hand so that you can easily press on the plunger.
-
Gently pinch the skin.
- Insert the needle swiftly, straight into the skin (90’ angle)
-
Press the plunger in a controlled, steady manner.
-
When fully injected, withdraw the needle and use clean gauze to stop any bleeding. Cover with bandaid if needed.
-
Put used ampules, needles and syringes into empty soda bottle, recap and dispose in trash.
(Area may get pink and swollen in a day or two; this is not cause for concern.)
|
|
|